Micropolis 1370-Series

DIMENSIONS AND MOUNTING INFORMATION

1370-SERIES DIMENSIONS AND MOUNTING INFORMATION The Micropolis 1370-Series drives use industry-standard mounting for 5 1/4-inch "full-height" Winchester disk drives. Recommended orientation is vertical on either side, or horizontal with the Device Electronics board down; other mounting orientations may be used provided the ambient air temperature around the drive is kept at or below 50° C (122° F). Since the drive acts as a heat sink to dissipate heat from the unit, the enclosure and mounting structure should be designed to allow natural convection of heat around the HDA and outer frame. If the enclosure is small or natural convection is limited, a fan may be required. The figure below shows the mounting hole locations.

Caution

The mounting screws must be selected so that they do not penetrate the mounting holes by more than 0.25 inch. Screws that are too long may short to PCBA components and/or prevent proper operation of the shock mount system. Maximum torque applied to the screws must not exceed 10 in-lbs.