Micropolis 1684-Models
CONFIGURATION INFORMATION
Configuration and Jumper Options
SCSI ID ID2 ID1 ID0
0 (default) out out out 1 out out in 2 out in out 3 out in in 4 in out out 5 in out in 6 in in out 7 in in in
Interface Termination RN9 provides termination for the SCSI interface lines. Default is RN9 installed. SCSI terminators are installed only in the end devices on the SCSI cable; remove them from each of the other devices.
Terminator Power A jumper is installed at W1, at W2, or at W2 and W31 to select the source of terminator power (+5V) for interface terminator RN6. Do not install terminators at both W1 and W31. If a jumper is installed at W1 (the factory default configuration, the drive provides terminator power. This configuration is used for PC/AT applications. If a jumper is installed at W2, terminator power is provided by the host computer via interface connector J1, pin 26. If jumpers are installed at both W2 and W31, the drive provides terminator power both to its own terminator and also to the SCSI bus via interface connector J1, pin 26.
Spindle Control A jumpers at W3 controls the spindle option.
No Jumper The drive starts the spindle motor at power-on. (Default)
Jumper The drive waits for a Start Unit SCSI command to
start the motor.
LED Color Option A jumper at W12 or W13 selects the color of the LED.
W12 W13
Yes No The red LED is selected
No Yes The green LED is selected. (Default)
Bus Parity Check A jumper at W9 selects the bus parity check option. The drive always generates parity regardless of this option.
Jumper SCSI interface parity checking disabled.
No Jumper SCSI interface parity checking on. (Default)
Frame Ground Option A jumper at W14 selects the frame ground option.
Jumper Frame ground connected to logic ground.
No Jumper Frame ground not connected to logic ground. (Default)