Micropolis 1991-Models

DIMENSIONS AND MOUNTING INFORMATION

1991 DIMENSIONS AND MOUNTING INFORMATION

All versions of the Micropolis 1991 drive use industry-standard mounting for 5 1/4-inch "full-height" Winchester disk drives. They are designed such that the outer frame should be hard-mounted to the host equipment; no additional or external shock mounts should be used.

Recommended orientation is vertical on either side, or horizontal with the Device Electronics board down; other mounting orientations may be used.

No matter what mounting orientation is used, Micropolis specifies that the maximum HDA temperature not exceed 60° C (140° F).

Caution

Mounting screws must not penetrate the bottom mounting holes by more than 0.20 inches, or the side mounting holes by more than 0.156 inches. Screws that are too long may short-circuit PCBA components.