1991W ELECTRICAL INTERFACE
Electrical interface between the Micropolis 1991W drive (with 16-bit, Single-Ended Interface) and the host system is accomplished via connectors as shown in the figure below.
Signal Connector J1 is a 68-pin interface connector. The signals on J1 include the 16-bit SCSI bus and various control and handshaking lines.
Power Connector J3 is a 4-pin connector used to supply +5V and +12V to the drive.
Connectors J4 and J5 are 3/16-inch spade lugs located on the HDA and frame, respectively, and are used for grounding purposes. System characteristics determine proper ground connection.
Multi-function Connector J2 is a 24-pin multi-function connector/jumper block, and is used for device addressing and various other options (see the Configuration Information for the particular drive model).
We use a cookie to enable basic features of our website.
By clicking on "accept", and by your continued use of this website, you agree to our practice of using and storing an essential cookie in your browser.
