Micropolis 21XX-Series

DIMENSIONS AND MOUNTING INFORMATION

2105/2108/2112 DIMENSIONS AND MOUNTING INFORMATION

The Micropolis 2105/2108/2112 drive (with 8-bit, Single-Ended Interface) uses industry-standard mounting for 3 1/2-inch "full-height" Winchester disk drives. They are designed such that the outer frame should be hard-mounted to the host equipment; no additional or external shock mounts should be used.

Recommended orientation is vertical on either side, or horizontal with the Device Electronics board down; other mounting orientations may be used provided the ambient air temperature around the drive is kept at or below 50° C (122° F).

Caution

Mounting screws must not penetrate the bottom mounting holes by more than 0.20 inches, or the side mounting holes by more than 0.156 inches. Screws that are too long may short-circuit PCBA components.