Micropolis hard Disk Drives, Specifications, Support, Specs, Jumpers, Manual, Images

Micropolis 1674-7

Hard Disk Drive

Overview

Model Capacity Size Height Interface Bus Type
Micropolis 1674-7 158MB 5.25" HHT SE SCSI1

Specifications

Size 5-1/4"
Interface SCSI
Encoding Method RLL
Formatted Capacity 157.8 MB
Disks 4
Heads 7
Cylinders 1249
Sectors 36
Buffer Size N/A
Average Seek 16 msec
Single Track 4 msec
Rotation Speed / Avg. Latency 3600 rpm +/- 0.5%
Transfer Rate to / from media 10 Mbits / sec
Transfer Rate to / from buffer N/A
Tracks Per Inch (TPI)
Bits Per Inch (BPI)
Dimensions 8.0"L x 5.75"W x 1.625"H
Weight 5.75 lbs.

Power Requirements

+12V +/-5% +5V +/-5% Power
Spin up 2.0A (max)
Read / Write .9A avg .7A avg
Typical 15 Watts

Notes

Drive Addressing and Interface Termination



ID0, ID1, ID2 SCSI Address Jumpers
  The SCSI ID (drive address) jumpers are identified as ID0, ID1, and ID2.
  ID selection is binary, as shown in the table below.

SCSI
Address
Jumpers
ID2 ID1 ID0
0 out out out
1 out out in
2 out in out
3 out in in
4 in out out
5 in out in
6 in in out
7 in in in

  For multiple drive installations, on one Host Adapter, each drive must
  have a unique address. Drives are configured as SCSI ID 0 at the factory.

RN9 Interface Terminator
  The Interface Terminator factory installed at RN9 provides proper termination
  for the interface lines. When daisy-chaining multiple drives, leave the terminator
  installed only in the last physical drive (or drives) on the daisy chain cable; remove
  the terminator from each of the other drives (or the host computer).

W1, W2 Terminator Option
  W1 and W2 select the source of terminator power (+5V) for the interface terminator.
  If a jumper is installed at W1 and no jumper is installed at W2 (the factory default
  configuration), the drive provides terminator power. This configuration is used for
  PC/AT applications. If no jumper is installed at W1 but a jumper is installed at W2,
  terminator power must provided by the host computer system via interface connector
  J1, pin 26.

W3, Spindle Option
  W3 selects the spindle control option. If W3 is installed, the drive waits for a Start
  Spindle command after power is applied to start the spindle motor. If W3 is not
  installed (the factory default configuration), the drive automatically starts the spindle
  motor at power-on. W3 is not installed for PC/AT installations.

W9 Bus Parity Option
  W9 selects the parity check option. If W9 is installed, the drive neither generates nor
  detects parity. If W9 is not installed (the factory default configuration), the drive generates
  parity and enables parity detection. W9 is usually not installed for PC/AT applications.
  Verify the correct configuration required by your Host Adapter.